b'Industry News2017 Architectural Sheet Metal Fascia and Coping Wind Test Report now available The entire SMACNA report Architectural Fascia SMACNA SMACNews March 8, 2017 and Coping Wind Tests Report is available on Volume 51, Number 3 the Technical Resources/Papers and Guidelines(WRCA) r TRB 01-17_x200SMACNAs 2017section of the SMACNA website.update for the Architectural Sheet Metal Fascia and Coping Wind Test Report describes thehttps://www.smacna.org/docs/default-source/performance of edge metal systems commonlytechnical-resources/trb-01-17-es-1-final-report.found within the SMACNA Architectural Sheetpdf?sfvrsn=2461f3a5_4Metal Manual, 7th edition.This report provides data that demonstrates that specimens fabricated according to Figures 2-1 and 3-1 in the SMACNA Architectural Sheet Metal Manual comply with and/or exceed the ANSI/SPRI/FM 4435 ES-1-2017 Test Standard for Edge Systems Used with Low Slope Roofing Standard, as required by the International Building Code (IBC).The wind uplift tests were conducted on custom-fabricated gravel stop fascia and coping designs shown in the SMACNA Architectural Sheet Metal Manual and in accordance with the parameters of the ANSI/SPRI/FM 4435 ES-1-2017 Test Standard for Edge Systems Used With Low Slope Roofing Standard.These specimens were tested at Intertek-ATI of York, Pa., an ANSI-accredited testing laboratory.Pride in our Profession!Midwest Roofing Contractors Association68 thANNUAL CONEXPOOCTOBER 16-18, 2017FOUNDATIONS E E Y O U I N St. Louis!'