b'THE OFFICIAL NFBA MAGAZINEPOST-FRAME TERMINOLOGY - MORE THAN JUST WORDSRESEARCH & TECHNOLOGYByAndy Williams, PENFBA Technical Consultant T he post-frame construction industry uses manythe center of a heavy timber truss is terms to describe the fabrication and constructionreferenced as:work being done. Some terms are recognizedA) Queen postnationally and understood by almost everyone involved in the construction industry. Other terms are moreB)King postregional or only referenced by specific trades. These terms are not so widely understood and can create confusion.C) Joker postFor post-frame construction many of the universalD)Tie beamterms were covered in the NFBA Post-Frame Building Design Manual published in 2015. Chapter 1 of thatThe answer as defined in the Architectural Term Glossary manual identified many of the common terms, along withis B) King post.drawings and pictures, used in post-frame construction. Having been in circulation for almost 10 years, the Post- Or perhaps: Identify the following architectural feature:Frame Building Design Manual has been an excellent resource. However, many of the more specific and/or regional terms are not called out in that manual. Because of this, the National Frame Building Association developed the Post-Frame Architectural Term Glossary which can be found in the public domain area of the NFBA website. (www.nfba.org) This is properly identified as a Flying Gable Overhang.An example of this might be: The vertical member atIts not always about putting a definition to a term. continued on page: 1514 / FRAME BUILDER - VOL5 6'